ADVANCED OPERATION
PC 
2, 3, 5
AUX1 
AUX2 
TUNER 
VIRTUAL | 5.I |
DIGITAL USB PCM | D. DSP |
PROLOGIC FM AM ST
VOL
DSP 
4
1
How to set
* When playback or recording is performed on the computer via the USB connection, terminate the playback or recording software used on the computer.
1 Turn on this unit.
Front panel
2 Press the PC input selector key repeatedly until “USB” appears on the display.
4 Press 
or 
repeatedly until the desired number of channels is shown on the display.
Front panel
The display changes as follows.
5 Hold down the PC input selector key until the following indication appears on the display.
PC 
AUX1 
AUX2 
TUNER | Front panel |
The number of | The number of |
channels before the | channels after the |
change | change |
Although no further operation is required, wait a short time
until the computer completes the changes in the settings.
PC 
AUX1 
Notes
ADVANCEDOPERATION
AUX2 
● When the number of channels is changed for the first time, the device driver for the USB audio is installed in
TUNER
Front panel
the computer. Wait a short time until the computer completes the changes in the setting.
3 Hold down the PC input selector key until the current channel setting is shown (for about two seconds). 
PC 
AUX1 
AUX2 
TUNER | Front panel |
*When the display of this unit shows “USB” in red, USB audio is being played back, disabling this USB channel setting function. Terminate the software used on the computer.
● Do not change the USB channel setting under any circumstance during playback or recording via the USB connection on the computer. If changed, the computer may freeze.
English