BASIC OPERATION
Note
When the PC, AUX1 or AUX2 input selector key is pressed, the display shows the name of the selected input source for a short while, and then shows the currently selected sound field program.
When no sound field program is selected, “THROUGH” is shown on the display.
The names of input sources shown on the display can be changed with the Application Software. Refer to the Online Help of the Application Software for details.
To cut off sound output temporarily
Press the MUTE key. To restore sound output, turn the volume control on the front panel or press the VOLUME keys on the remote control. Pressing the MUTE key again also restores sound output.
MUTE
Remote control
Note
Sound output will also be restored by changing the status of this unit between standby and
When you listen with headphones
Connect the headphones to the headphone jack. No
sound will be outputted from the speakers.
When you have finished using this unit
Set this unit to the standby mode by pressing the power
switch on the front panel or the POWER key on the remote
control.
POWER
or
Front panel | Remote control |
Note
When not planning to use this unit for a long period (i.e., vacation, etc.), disconnect the AC power plug from the wall outlet.
Setting USB MIX
When an input other than the USB terminal is selected, you can listen to the mixed signals from the selected input and from the USB terminal. Also, the mixing ratio of the signals from the USB terminal can be adjusted.
*Refer to the online help of the Application Software for details.
Setting graphic equalizer
You can adjust the frequency characteristics as you prefer by using the
*Refer to the online help of the Application Software for details.
Notes
●Some setting changes may be needed on the computer to reproduce signals sent from the computer to this unit via the USB connection. Refer to the separate “SET UP MANUAL” for details.
●Some setting changes may be needed on the computer to reproduce signals sent from the computer to this unit via a sound card, etc.
Automatic power saving function
If there is no operation on this unit’s front panel, the remote control or the Application Software for about 24 hours with the power of this unit on, this unit will automatically be set to the standby mode.