INSTALLING USB DRIVER AND APPLICATION SOFTWARE

Make the following settings on your computer after the installation of the driver is finished.

Setting of Audio and Audio CD

1 Click the Windows “Start” button and select “Settings”, and then “Control Panel”.

2 Double-click the “Sounds and Multimedia” icon.

3 Click the “Audio” tab and select “USB Audio

Device” at “Preferred device” of “Sound Playback”.

* Usually, this setting is automatically made.

4 Click the “Hardware” tab and double-click the item of the DVD or CD-ROM to be used in the “Devices”.

5 Click the “Properties” tab, and click the check box of “Enable digital CD audio for this CD-ROM device” to enter the check mark.

*It may happen that the check box cannot be clicked because some CD-ROM drives cannot be used for playing audio CDs.

Checking sound output and adjusting volume

PC PC

AUX1

AUX2

TUNER

VIRTUAL Display

VOL

DSP P-SET

Volume control

Power switch

1 Make the following operations on the front panel of this unit.

a) Press the power switch to turn on this unit. (Some messages are shown on the display.)

b) Press the PC input selector key repeatedly to

6 Restart Windows, and log in with Administrator.

select USB as the input source.

INSTALLING

Note

c) Use the volume control to adjust the volume. (Set the control to about “30”.)

APPLICATION

USB

When using two or more drives, you must make the above setting

for each drive.

2 Adjust the volume on the computer as follows.

a) Double-click the speaker icon on the task tray, or select “Start”, “Programs”, “Accessories”, “Entertainment” in this order and click “Volume Control”.

(The volume adjustment window appears.)

b) Adjust the volume by dragging the “Volume” slider. Set the slider between the center and max. position.

* Do not enter the check mark in the “Mute” check box. If entered, sound output will stop.

3 Click the Windows “Start” button and select “Settings”, and then “Control Panel”.

4 Double-click the “Sounds and Multimedia” icon.

5 Click the “Sounds” tab.

6 Check that the sound is output normally by outputting “Default Beep”, etc. from “Sound Events”.

* If no sound is heard, restart Windows and check again.

DRIVERSOFTWARE AND

English

E-15