Yamaha RX-V1 ■Connecting a Turntable, ■ Connecting a CD Player

Preparations

Hookups

Connecting Audio Components

Before you connect any components, disconnect the power supply to all the components you plan to connect including the RX-V1 and determine which jacks are for the left and right channels and for input and output.

When you connect other YAMAHA audio equipment (such as a CD player or changer, MD deck, or tape deck, connect to terminals with the same number labels. Yamaha applies this labelling system to all its products.

In the hookup illustrations on the following pages:

indicates signal direction,

C indicates coaxial cables,

L indicates left side analog cables,

R indicates right side analog cables,

Oindicates optical cables; and,

Sindicates S-video cables.

After you finish all hookups, check them again to make sure they are correct.

			Output
			L
Turnable			R
		Ground
RF(AC-3)	GND	AUDIO	AUDIO	VIDEO
		PHONO	VIDEO	S VIDEO
LD			DVD
CD	CD		LD
DVD			D-TV
CBL	IN		CBL

■Connecting a Turntable

1Connect the left and right signal output cords to the PHONO L and R jacks.

Note:

•These jacks are for connecting a turntable with an MM or high output MC cartridge. If you have a turntable with a low output MC cartridge, use an inline boosting transformer or MC-head amplifier when connecting to these jacks.

Caution:

•The GND terminal does not electrically ground the turntable. It simply reduces noise in the signal. In some cases, you may hear less noise if you do not connect to the GND terminal.

Optical Output			Analog Output			■ Connecting a CD Player
	CD player			L
				R		1 Connect the left and right analog signal output jacks on your CD
	Coaxial Output					player to the CD 1 L and R jacks.
	C
	RF(AC-3)	GNDPHONO	VIDEO	S VIDEO	Y	Notes:
		AUDIO	AUDIO	VIDEO	COMPONE
	LD		DVD		A
						• The COAXIAL CD and OPTICAL CD jacks are available for a CD player which
O	CD	CD	LD		B
						has coaxial or optical digital outputs.
			D-TV		C
	DVD
						• When you connect a CD player to both the COAXIAL CD and OPTICAL CD
	CBL	IN	CBL
	/SAT	(PLAY)	/SAT			jacks, priority is given to the input signals from the COAXIAL CD jack.
	OPTICAL	TAPE
	COAXIAL
		OUT	IN
	CD
		(REC)	OUT			• The OPTICAL jacks on this unit conform to the EIA standard. If you use a fiber
	IN	IN
			VCR 1
	(PLAY)	(PLAY)	IN			optic cable that does not conform to this standard, the RX-V1 may not function
	MD	MD
					IN
	OUT	OUT			REMOTE 1	properly.
	(REC)	(REC)
			VCR 2		OUT
	DVD	MAIN	OUT

16