How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is the + and – markings are observed. If these wires are reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other and do not let them touch any metal part of this unit. This could damage this unit and/or speakers.

For connecting to the FRONT SPEAKERS terminals

For connecting to the REAR and CENTER SPEAKERS

 

terminals

Red: positive (+)

 

Black: negative (–)

2

1

3

➀Unscrew the knob.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from

the speaker wires.]

➂Tighten the knob and secure the wire.

Red: positive (+)

Black: negative (–)

➀

➂ ➁

➀Press the tab.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from the speaker wires.]

➂Release the tab and secure the wire.

<U.S.A. and General models only>

Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal.

ABOUT THE ACCESSORY TERMINALS
AC OUTLET(S) (SWITCHED)

(U.S.A., Europe and General models)

 

..........................................................

2 SWITCHED OUTLETS

(U.K. model) ........................................

1 SWITCHED OUTLET

Use these to connect the power cords from your components to this unit.

The power to the SWITCHED outlets is controlled by this unit’s POWER switch or the provided remote control transmitter’s POWER key. These outlets will supply power to any component whenever this unit is turned on.

The maximum power (total power consumption of components) that can be connected to the SWITCHED AC OUTLET(S) is 100 watts.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to the GND terminal will normally minimize hum, but in some cases better results may be obtained with the ground wire disconnected.

Note

Even if you make this connection, never fail to make other wire connections to this terminal. (See page 11.)

10