You can also make use of an automatic preset tuning function for FM stations only. By this function, this unit performs automatic tuning and stores FM stations with strong signals sequentially. Up to 40 stations are stored automatically in the same way as in the manual preset tuning method on page 23.
*<Europe and U.K. models only>
Only RDS stations can be stored by this function.
1 2
To store stations1 FM/AM
FM
2MEMORY
When the automatic preset tuning is finished
The display shows the frequency of the last preset station. Check the contents and the number of preset stations by following the procedure of the section “To recall a preset station” on page 23.
To recall a preset station
Simply follow the procedure of the section “To recall a preset station” on page 23.
MAN’L/AUTO
Press and hold for about 3 seconds.
*<Europe and U.K. models only>
A recalled station is shown by the frequency or station name on the display.
Notes
•You can replace a preset station by another FM or AM station manually by simply following the procedure of the section “To store stations” on page 23.
<U.S.A. and General models only>
MEMO PRESET
AUTO
Flashes.
The automatic preset tuning begins from A1. Received stations are programmed to A1, A2 ... A8 sequentially.
*If more than 8 stations are received, they are also programmed to the preset station numbers on other groups (B, C, D and E) in that order.
•If the number of received stations is not enough to be stored up to E8, the search will be finished automatically after searching all frequencies.
•With this function, only FM stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 23.
<Europe and U.K. models only>
•The automatic preset tuning search is performed through all RDS network frequencies until stations are stored up to E8. If the number of received stations is not enough to be stored up to E8, the search will be finished automatically after searching all frequencies.
•With this function, only RDS stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune to it in monaural manually and program it by following the procedure of the section “To store stations” on page 23.
*There may be a case that this function cannot receive a station which could be received by the automatic tuning method. This is because this function receives a large volume of PI (Program Identification) data along with the station.
24