TO RECORD A SOURCE TO TAPE (OR DUB FROM TAPE TO TAPE)

1 2

1 Select the source to be recorded.

INPUT

DVD-LD/VCR/TAPE/CD/TUNER/PHONO

5CH / 2CH

2 Play the source and then turn the VOLUME control up to confirm the input source. (For detailed information on the tuning operations, refer to the page 22.)

VOLUME

0I0

3 Begin recording on the tape deck or VCR connected to this unit.

Notes

●The settings of DSP and the VOLUME, BASS, TREBLE and BALANCE control settings have no effect on the material being recorded.

●In step 1, do not make an input source selection so that “DVD 5cH” appears on the display. Signals input to this unit’s DVD/LD 5CH DISCRT INPUT terminals cannot be recorded by a tape deck or a VCR.

Selecting the SPEAKER system

Because one or two speaker systems (as front speakers) can be connected to this unit, the SPEAKERS switches allow you to select speaker system A or B, or both at once.

SPEAKERS

B

ON OFF

A

Adjusting the BALANCE control

Adjust the balance of the output volume to the left and right speakers to compensate for sound imbalance caused by speaker location or listening room conditions.

BALANCE

L R

Note

This control is effective only for the sound from the front speakers.

Adjusting the BASS and TREBLE controls

BASSTREBLE

00

–

+

–

+

BASS : Turn this clockwise to increase (or counterclockwise to decrease) the low frequency response.

TREBLE : Turn this clockwise to increase (or counterclockwise to decrease) the high frequency response.

Note

These controls are effective only for the sound from the front speakers.

English

21