Yamaha RX-V1000 ■AC OUTLET(S) (SWITCHED), IMPEDANCE SELECTOR Switch, Connecting the Power Supply Cords, ■VOLTAGE SELECTOR (China and general models only)

CONNECTIONS

IMPEDANCE SELECTOR Switch

WARNING

Do not change the IMPEDANCE SELECTOR switch setting while the power of this unit is on, otherwise the unit may be damaged.

If this unit fails to turn on when STANDBY/ON (or SYSTEM POWER) is pressed, the IMPEDANCE SELECTOR switch may not be fully slid to either position. If so, slide the switch to either position fully when this unit is in the standby mode.

Select the left or right position according to the impedance of the speakers in your system. Be sure to move this switch only when this unit is in the standby mode.

(General model)

Left

each speaker must be 8 Ω or higher.

PREPARATION

Switch

Speaker

Impedance level

VOLTAGE SELECTOR

position

If you use one set of main speakers, the impedance of each

Main

speaker must be 4 Ω or higher.

VOLTAGE SELECTOR

If you use two sets of main speakers, the impedance of

IN

AC OUTLETS

Center

The impedance must be 6 Ω or higher.

SWITCHED

T

100W MAX. TOTAL

Rear

The impedance of each speaker must be 6 Ω or higher.

IN

If you use one set of main speakers, the impedance of each

speaker must be 8 Ω or higher.

If you use two sets of main speakers, the impedance of

SET BEFORE POWER ON

IMPEDANCE SELECTOR

Main

each speaker must be 16 Ω or higher.

A + B: 8

MIN. /SPEAKER

A + B:16 MIN. /SPEAKER

MAIN A OR B: 4

MIN. /SPEAKER

MAIN A OR B: 8

MIN. /SPEAKER

CENTER

: 6

MIN. /SPEAKER

CENTER

: 8

MIN. /SPEAKER

Right

[Canada model only]

REAR

: 6

MIN. /SPEAKER

REAR

: 8

MIN. /SPEAKER

The impedance of each speaker must be 8 Ω or higher.

Center

The impedance must be 8 Ω or higher.

Rear

The impedance of each speaker must be 8 Ω or higher.

IMPEDANCE SELECTOR

■VOLTAGE SELECTOR (China and general models only)

The VOLTAGE SELECTOR on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110/120/220/240 V AC, 50/60 Hz.

Connecting the Power Supply Cords

After completing all connections, connect the AC power cord to an AC power outlet. Disconnect the AC power cord if you will not use this unit for a long period of time.

■AC OUTLET(S) (SWITCHED)

(General model)

VOLTAGE SELECTOR

NAC OUTLETS SWITCHED

						100W MAX. TOTAL
N
T
		IMPEDANCE SELECTOR
			SET BEFORE POWER ON
	MAIN A OR B: 4			MIN. /SPEAKER	MAIN A OR B: 8		MIN. /SPEAKER
		A + B: 8 MIN. /SPEAKER				A + B:16	MIN. /SPEAKER
	CENTER	: 6		MIN. /SPEAKER	CENTER	: 8	MIN. /SPEAKER
	REAR	: 6		MIN. /SPEAKER	REAR	: 8	MIN. /SPEAKER

To AC outlet

U.S.A., Canada, Singapore, China and
general models ..............................................	2 OUTLETS
Australia model ...............................................	1 OUTLET

Use these outlets to connect the power cords from your components to this unit. The power to the AC OUTLET(S) is controlled by this unit’s STANDBY/ON (or SYSTEM POWER and STANDBY). These outlets will supply power to any connected component whenever this unit is turned on. The maximum power (total power consumption of components) that can be connected to the AC OUTLET(S) is 100 W.

English

SWITCHED 19