Yamaha RX-V1000 Remote Control in Zone, ■Special considerations when using DTS software, For CDs encoded with DTS, 2Press l / h to select “L:AMP”, • LDs, • DVDs

ZONE 2

■Special considerations when using DTS software

The DTS signal is a digital bitstream. Therefore, if you attempt to send the DTS signal to the second room, you will only be able to hear the digital noise sound that could damage your speakers.

Due to this characteristic of DTS encoded discs, the following considerations and adjustments need to be made.

For LDs or DVDs encoded with DTSOnly 2-channel analog audio signals may be sent to the second room, as follows:

• LDs

Set your LD player’s left and right outputs to the analog soundtrack.

• DVDs

Use the disc menu to set the DVD player’s mixed 2- channel left and right audio outputs to the PCM or Dolby Digital soundtrack.

For CDs encoded with DTSDO NOT USE the Zone 2 feature for CDs encoded with DTS.Remote Control in Zone 2

In the second room (Zone 2), the supplied remote control can be used for the Zone 2 remote control. You can select the input source and control the component which is located in the main room directly from the second room regardless of the listening condition in the main room.

Before starting the following procedure, set REC OUT/ ZONE 2 on the front panel to SOURCE/REMOTE.

1Repeat steps 1 and 2 of the procedure in “Setting the Manufacturer Code” on page 54.

2Press l / h to select “L:AMP”.

			6CH INPUT
		TITLE
			ENTER
SOURCE
	DISPLAY	MENU	SOUND
SELECT	SEARCH		– CHAPTER +

POWER REC STOP PAUSE PLAY

/

3Press k / n to select “Zone2”.

				6CH INPUT
		TITLE
			ENTER
SOURCE
	DISPLAY	MENU		SOUND
SELECT	SEARCH		–	+

POWER REC STOP PAUSE PLAY

/

4Press LEARN to complete the Zone 2 setup.

LEARN

5Press SOURCE SELECT k to display “Zone2” in the display window.

SOURCE

SELECT

6Press an input selector button to select the input source you want to listen to in the second room.

The display window shows “2: name of selected input” if the remote control is in the Zone 2 mode.

SYSTEM
POWER	STANDBY			PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR 2/DVR	DVD

7You can control the component by using the component control area buttons.

					6CH INPUT
		TITLE
				ENTER
SOURCE
	DISPLAY	MENU			SOUND
SELECT	SEARCH			– CHAPTER +
POWER	REC	STOP		PAUSE	PLAY
/
10KEY DSP	HALL 1	HALL 2		CHURCH	JAZZ CLUB
	1	2		3	4
	ROCK			ENTER-	TV
	CONCERT	STADIUM		TAINMENT	SPORTS
	5	6		7	8
6.1/ES	MONO	MOVIE		MOVIE	/DTS
	MOVIE	THEATER 1		THEATER 2	SUR.
	9	10		11	12
CHP/INDEX		0		+10	+100
	A / B / C / D / E	PRESET
+	TV INPUT	+		MUTE	+
TV VOL		CH			VOLUME
–	TV MUTE	–	EFFECT		–

DISC

Note

•Adjust the Zone 2 volume with the control on the amplifier in the second room.

8Press SOURCE SELECT k / n to exit from the Zone 2 mode.

SOURCE

SELECT

62