Yamaha RX-V1000 SUR.), Using the Test Tone (TEST DOLBY, 1,5, same, English, adjusted, the output level coming, select the speaker to be, 4 Press –/+repeatedly to

Using the Test Tone (TEST DOLBYSUR.)Use the test tone to balance the output levels of the

6 speakers required for a surround sound system. The adjustment of each speaker output level should be made at your listening position with the remote control. After completing the adjustments, use VOLUME +/– at your listening position to check if the adjustments are satisfactory.

		A / B / C / D / E PRESET
	+	TV INPUT	+	MUTE	+	2
	TV VOL		CH		VOLUME
	–	TV MUTE	–	EFFECT	–
			DISC
					PARAMETER	3
	ON SCREEN LEVEL
					SET MENU
1,5	SLEEP	TEST
						4

1Press TEST to output the test tone.

TEST

2Adjust the volume so you can hear the test tone.

The test tone is heard from the left main speaker, center speaker, right main speaker, right rear speaker, rear center speaker (see page 17) and left rear speaker in order. The tone is produced for

2.5 seconds each time.

	LEFT	RIGHT
	(TEST LEFT) (TEST RIGHT)
+		CENTER
VOLUME	(TEST CENTER)

–

LEFT SURROUND	RIGHT SURROUND
(TEST L SUR.)		(TEST R SUR.)

REAR CENTER

(TEST R CENTER)

ADJUSTING THE SPEAKER OUTPUT LEVELS

The state of the test tone output is also shown on the monitor by an image of the audio listening room. This is convenient for adjusting each speaker level.

TEST DOLBY SUR.

LEFT

y

• If “1A CENTER SP” on the SET MENU is set to NONE, the
center channel sound is automatically output from the left and	PREPARATION
right main speakers.
Note
• If the test tone cannot be heard, turn down the volume, set the
unit in the standby mode and check the speaker connections.
3 Press k / n repeatedly to
select the speaker to be
adjusted.
y
• You can stop the sequence temporarily by holding down k/ n.
4 Press –/+ repeatedly to
adjust the output level of
the effect speakers so that
the output level coming
from each speaker is the
same.

While adjusting, the test tone is heard from the selected speaker.5When the adjustment is complete, press TEST.

The test tone stops and the	TEST
current DSP program appears
on the front panel display and
on the video monitor.

y

•The tonal quality of the center speaker can be adjusted by using “5 CENTER GEQ” on the SET MENU (see page 41).

•You can increase the output levels of the effect speakers (center, left rear, right rear and rear center) to +10 dB. If the output level of these speakers is lower than that of the main speakers even after you have increased the output level of these speakers up to +10 dB, set “1F MAIN LEVEL” on the SET MENU to –10 dB (see page 40). This setting decreases the main speaker output level to about one-third of the normal level. After you have set “1F MAIN LEVEL” on the SET MENU to –10 dB, adjust the levels for the center, rear and rear center speakers again.

English

23