Yamaha RX-V1000 Programming a New Remote, Control Function (Learn Feature), English, category), 1 Set 10KEY/DSP to 10KEY, select a source component

■Controlling a different component from the source component (input) you have selected

1Repeat steps 1 and 2 of the procedure in “Setting the Manufacturer Code”.2Press l / h to select a library (componentcategory).

			6CH INPUT
		TITLE
SOURCE
	DISPLAY	MENU	SOUND
SELECT	SEARCH		– CHAPTER +

POWER REC STOP PAUSE PLAY

/

There are 13 libraries to set up a manufacturer code: L:TV, L:CAB (CABLE), L:DBS, L:SAT, L:VCR, L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP (TAPE), L:TUN (TUNER) and *L:AMP.

3Repeat steps 3 and 4 of the procedure in “Setting the Manufacturer Code”.About amplifier libraries (L:AMP)

L:AMP has 4 codes: YPC, Zone2, DSP, and No. “YPC” or “Zone2” should be selected to operate this unit. “DSP” is for operating YAMAHA DSP amplifiers other than this unit. “No” is to clear this unit control area functions.

Note

•“YPC” is factory-set as the amplifier library. When you make up a second audio-video room with this unit’s Zone 2 feature, you must set “Zone2” as the amplifier library in the remote control (see page 62 for details).

REMOTE CONTROL FEATURES

Programming a New RemoteControl Function (Learn Feature)

If you want to program functions not included in the basic operations covered by the manufacturer code, or a manufacturer code is not available, the following procedure needs to be performed. The possible programming area is the same as a component control area, so the buttons are programmable independently for each source component area.

Note

•This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of the other remote control’s functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.)

1 Set 10KEY/DSP to 10KEY. 10KEY DSP

2Press an input selector button, A or B toselect a source component.

SYSTEM
POWER	STANDBY			PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
D-TV/LD	CBL/SAT	VCR 1	VCR 2/DVR	DVD

3 Place this remote control and the other					ADVANCED OPERATION
remote control about 50 to 100 mm (2 to
4 in.) apart on a flat surface so that their
infrared transmitters are aimed at each other.
	TV/LD-D	AUX-V	SYSTEM POWER	TRANSMIT
TITLE	1 VCR CBL/SAT	MD/TAPE TUNER	STANDBY	LEARN CLEAR NAME-RE
ENTER	2/DVR VCR	R-CD		MACRO
INPUT 6CH	DVD	CD	PHONO	MACRO ON OFF

about 50 to 100 mm (2 to 4 in.)

English

55