CONNECTIONS

Connecting the Antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal

strength.

Connect each antenna correctly to the designated terminals.

FREQUENCY STEP switch (For China and General models)

■Connecting the AM loop antenna

1 Set up the AM loop antenna, then connect it.

100kHz/10kHz

50kHz/9kHz

FM AM

FREQUENCY

STEP

Because the interstation frequency spacing differs in different areas, set the FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area.

North, Central and South America:

100 kHz/10 kHz

Other area: 50 kHz/9 kHz

Before setting this switch, disconnect the AC power plug of this unit from the AC outlet.

2 Press and hold the tab to insert the AM loop

antenna lead wires into the AM ANT and GND terminals.

PREPARATION

AM loop antenna

(included)Indoor FM antenna (included)

COMPONENT VIDEO

PR/ CR

PB/ CB

Y

VD

BL

AT

ITOR

UT

W

TUNER

AM

ANT

GND

FM ANT

3 Release the tab to fix the lead wires.

75Ω

C

UNBAL.

CGround (GND terminal)

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

■Connecting the indoor FM antenna

Connect the included indoor FM antenna to the 75Ω UNBAL. FM ANT terminal.

y

•The AM loop antenna can be removed from the stand and attached to a wall, etc.

•Orient the AM loop antenna for the best reception.

Notes

•The AM loop antenna should be placed away from this unit.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas.

English

19