REMOTE CONTROL FEATURES

6 Press and hold the button on the other remote control that has the function you want to program into this remote control until “OK” appears in the display window.

ENTER

TITLE

TV/LD-D

AUX-V

SYSTEM POWER

TRANSMIT

1VCRVCR2/DVRCBL/SAT

R-CDMD/TAPETUNER

BA

MACROLEARNCLEAR NAME-RE

 

 

 

 

STANDBY

 

 

INPUT 6CH

DVD

CD

PHONO

MACRO ON OFF

Notes

•“NG” appears in the display window when programming has not been done correctly. In this case, start over from step 5.

•This remote control can learn approximately 120 functions. However depending on the signals learned, “FULL” may appear in the display window much earlier than this number. In this case, clear unnecessary programmed functions to make further learning on the remote control.

7 Repeat steps 5 and 6 to program additional functions.

8 Press LEARN again to exit from the learning mode.

LEARN

Notes

•Learning may not be possibe in the following cases:

–when the batteries in the remote control for this unit or other components are weak

–when the distance between the two remote controls is too much or too little

–when the remote control infrared windows are not facing at the appropriate angle

–when the remote control is exposed to the direct sunlight

–when the function to be programmed is continuous or uncommon

•“ERROR” appears in the display window when pressing more

than one button at once.

Changing the Source Name in the

Display Window

You can change the name that appears in the display window on the remote control if you want to use the different name from the original input selector button names. This is useful when different component is set in the input selector button.

1 Press an input selector button, Å or ı to select the source component you want to rename.

The selected component name appears in the display window.

 

 

A

B

PHONO

V-AUX

TUNER

MD/TAPE

CD-R

CD

D-TV/LD

CBL/SAT

VCR 1

VCR2/DVR

DVD

2 Press RE-NAME by using

RE-

a ballpoint pen or similar object.

3 Press k / n to select a character.

Choices are A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash).

ENTER

4 Press l / h to move the cursor to the next position.

ENTER

y

•If you continuously want to rename another source component, press ENTER and repeat steps 1, 3 and 4.

5 Press RE-NAME again to exit from the renaming mode.

RE-NAME

Note

•“ERROR” appears in the display window when pressing butons other than indicated in each step, or more than one button at once.

46