For 2CH STEREO:

Direct DIRECT

 

Function:

2-channel stereo direct. Bypasses the

 

decoders and DSP processors of this unit

 

for pure hi-fi stereo sound when playing

 

2-channel analog sources.

Choices:

AUTO, OFF

y

The “AUTO” setting bypasses the decoders and DSP processors only when “BASS” and “TREBLE” are set to 0 dB (see

page 24).

When multi-channel signals (Dolby Digital and DTS) are input, they are downmixed to 2 channels and output from the front left and right speakers.

The low-frequency signals input from the front left and right speakers are redirected to the subwoofer in the following cases:

“BASS” is set to “BOTH” (see page 54).

“FRONT” is set to “SML” (see page 54) and “BASS” is set to “SWFR” (see page 54).

For PRO LOGIC II Music:

Panorama PANORAMA

Function:

Sends stereo signals to the surround

 

speakers as well as the front speakers for

 

a wraparound effect.

Choices:

OFF, ON

Dimension DIMENSION

Function:

Gradually adjusts the sound field either

 

towards the front or towards the rear.

Control range:

–3 (towards the rear) to +3 (towards the

 

front), initial setting is STD (standard).

Center width CT WIDTH

Function:

Adjusts the center image from all three

 

front speakers to varying degrees. A

 

larger value adjusts the center image

 

towards the front left and right speakers.

Control range:

0 (center channel sound is output only

 

from center speaker) to 7 (center channel

sound is output only from front left and right speakers), initial setting is 3.

SOUND FIELD PROGRAMS

Using Virtual CINEMA DSP

Virtual CINEMA DSP allows you to enjoy the CINEMA DSP programs without surround speakers by creating virtual speakers.

If you set “SURR” to “NONE” (see page 54), Virtual CINEMA DSP activates automatically whenever you select a CINEMA DSP program (see page 31).

Note

Virtual CINEMA DSP will not activate even when “SURR” is set to “NONE” (see page 54) in the following cases:

When “2CH STEREO” (see page 31) is selected or when this unit is in the “STRAIGHT” mode.

When the component connected to the MULTI CH INPUT jacks is selected as the input source (see page 25).

When headphones are connected to the PHONES jack.

Listening to unprocessed input signals

When this unit is in the “STRAIGHT” mode, multi- channel sources are decoded straight into the appropriate channels without any additional effect processing. 2- channel stereo sources are output from only the front left and right speakers.

1Press AMP on the remote control and then STRAIGHT to select “STRAIGHT”.

AMP

STRAIGHT

ENT.

2To deactivate the “STRAIGHT” mode, press STRAIGHT on the remote control again so that “STRAIGHT” disappears from the front panel display.

The sound field program is turned back on.

y

You can also select “STRAIGHT” by pressing STRAIGHT on the front panel.

OPERATION

BASIC

 

 

English

33