TROUBLESHOOTING

Problem

Cause

Remedy

See

page

 

 

 

The sound suddenly

The protection circuitry has been activated

Check that the impedance selector setting is correct.

9, 11

goes off.

because of a short circuit, etc.

 

 

Check that the speaker wires are not touching each

 

 

 

 

other and then turn this unit back on.

 

 

 

 

 

 

The sleep timer has turned off this unit.

Turn on this unit, and play the source again.

 

 

 

 

 

The sound is muted.

Press MUTE or VOLUME +/– on the remote control

25

 

 

to resume audio output.

 

 

 

 

 

Sound is heard from

Incorrect cable connections.

Connect the cables properly. If the problem persists,

13-17

the speaker on one

 

the cables may be defective.

 

side only.

 

 

 

Incorrect settings in “SP LEVEL”.

Adjust the “SP LEVEL” settings.

26

 

 

 

 

 

Only the center

When playing a monaural source with a

 

 

speaker outputs

CINEMA DSP program, the source signal

 

 

substantial sound.

is directed to the center channel, and the

 

 

 

front and surround speakers output effect

 

 

 

sounds.

 

 

 

 

 

 

No sound is heard

“CENTER” in “SET MENU” is set to

Set “CENTER” to “SML” or “LRG”.

53

from the center

“NONE”.

 

 

speaker.

 

 

 

One of the HiFi DSP programs (except for

Try another sound field program.

30

 

 

5ch Stereo) has been selected.

 

 

 

 

 

 

No sound is heard

“SURR” in “SPEAKER SET” is set to

Set “SURR” to “SML” or “LRG”.

54

from the surround

“NONE”.

 

 

speakers.

 

 

 

This unit is in the “STRAIGHT” mode

Press STRAIGHT on the front panel so that

33

 

 

and a monaural source is being played

“STRAIGHT” disappears from the front panel

 

 

back.

display.

 

 

 

 

 

No sound is heard

“BASS” in “SPEAKER SET” is set to

Set “BASS” to “SWFR” or “BOTH”.

54

from the subwoofer.

“FRNT” when a Dolby Digital or DTS

 

 

 

signal is being played.

 

 

 

 

 

 

 

“BASS” in “SPEAKER SET” is set to

Set “BASS” to “BOTH”.

54

 

“SWFR” or “FRNT” when a 2-channel

 

 

 

source is being played.

 

 

 

 

 

 

The source does not contain low- frequency bass signals.

INFORMATION

ADDITIONAL

English

61