SET MENU

Surround left/right speakers 1C SURR

Choices: LRG (large), SML (small), NON (none)

Select “LRG” if you have large surround left and right speakers. The entire range of the surround channel signals is directed to the surround left and right speakers.

Select “SML” if you have small surround left and right speakers. The low-frequency signals of the surround channel are directed to the speakers selected with “1D BASS”.

Select “NON” if you do not have surround speakers. This will set this unit to the Virtual CINEMA DSP mode (see page 33).

Bass out 1D BASS

Use this feature to select the speakers that output the LFE (low-frequency effect) and the low-frequency signals. Choices: SWFR (subwoofer), FRNT (front), BOTH

Select “SWFR” if you connected a subwoofer. The LFE signals as well as the low-frequency signals of other speakers set to “SML” or to “NON” are directed to the subwoofer.

Select “FRNT” if you did not connect a subwoofer. The LFE signals, the low-frequency signals of the front left and right channels, and the low-frequency signals of other speakers set to “SML” or to “NON” are all directed to the front left and right speakers regardless of the “1B FRONT” setting.

Select “BOTH” if you connected a subwoofer. The low-frequency signals of any source are output from the subwoofer. The LFE signals as well as the low- frequency signals of other speakers set to “SML” or to “NON” are directed to the subwoofer. The low- frequency signals of the front left and right channels are directed to the front left and right speakers and the subwoofer regardless of the “1B FRONT” setting.

Speaker distance 2 SP DISTANCE

Use this feature to manually adjust the distance of each speaker and the delay applied to the respective channel. Ideally, each speaker should be the same distance from the main listening position. However, this is not possible in most home situations. Thus, a certain amount of delay must be applied to the sound from each speaker so that all sounds will arrive at the listening position at the same time.

Unit UNIT

Choices: meters, feet Initial setting:

[U.S.A. and Canada models]: feet

[Other models]: meters

Select “meters” to adjust speaker distances in meters.

Select “feet” to adjust speaker distances in feet.

Speaker distances

Control range: 0.30 to 24.00 m (1.0 to 80.0 ft)

Control step: 0.10 m (0.5 ft)

Initial settings: 3.00 m (10.0 ft)

Select “FRONT” to adjust the distance of the front speaker.

Select “CENTER” to adjust the distance of the center speaker.

Select “SURR” to adjust the distance of the surround speaker.

Notes

“CENTER” and “SURR” cannot be adjusted if “1A CENTER” and “1C SURR” are set to “NON” respectively.

No delay will be set if you set the same distance for “FRONT”, “CENTER”, and “SURR”.

Low-frequency effect level 3 LFE LEVEL

Use this feature to adjust the output level of the LFE (low- frequency effect) channel according to the capacity of your subwoofer or headphones. The LFE channel carries low-frequency special effects which are only added to certain scenes. This setting is effective only when this unit decodes Dolby Digital or DTS signals.

Control range: –20 to 0 dB

Control step: 1 dB

Speaker SP LFE

Adjusts the speaker LFE level.

Headphone HP LFE

Adjusts the headphone LFE level.

Notes

Adjust the LFE level according to the capacity of your subwoofer or headphones.

Depending on the settings of “1D BASS”, some signals may not be output at the SUBWOOFER OUTPUT jack.

54