BASIC OPERATIONS

2

3

1, 6

English

4 7 7

TO PLAY A SOURCE

1

Set to the “∞ ” position.

2

POWER

 

3 Select the desired input source by using the input selector buttons.

(For video sources, turn the TV/monitor ON.)

TAPE

MONITOR TUNER CD PHONO

VIDEO AUX VCR 2

LD/TV

*The name of the selected input source will appear in the display.

4 Select the front speakers to be used.

SPEAKERS

A B

ON ON

OFF OFF

*If you use two front speaker systems, press both the A and B switches.

5 Play the source. (For detailed information on the tuning operation, refer to page 18.)

6

Adjust to the desired output level.

7 If desired, adjust the BASS, TREBLE, BALANCE controls, etc. (refer to page 17) and use the digital sound field processor. (Refer to page 24.)

Notes on using the input selector buttons

●Note that pressing on each input selector button selects the source which is connected to the corresponding input terminals on the rear panel.

*To select the source connected to the VIDEO AUX terminals on the front panel, press VIDEO AUX.

●The selection of TAPE MONITOR cannot be canceled by pressing another input selector button. To cancel it, press TAPE MONITOR again.

When you select a button other than TAPE MONITOR, make sure that TAPE MONITOR is not also selected.

●If you select the input selector button for a video source without canceling the selection of TAPE MONITOR, the playback result will be the video image from the video source and the sound from the audio tape.

●Once you play a video source, its video image will not be interrupted even if the input selector button for an audio source is selected.

To turn off the power

Press the POWER switch again.

15