CONNECTING SPEAKERS
Connect the respective speakers to this unit as figured below.
Rear speakers
RightLeft
Center speaker
8ΩMIN. |
| OUTPUT | |
/SPEAKER | FRONT | CENTER REAR | |
REAR |
|
| |
CENTER |
|
| |
C | D |
| |
| DUAL | LOW | |
C D:4ΩMIN./SPEAKER | SINGLE | PASS | |
fc:200Hz | |||
SINGLE:8ΩMIN./SPEAKER SPEAKERS | |||
| |||
| SPEAKERS |
| |
A | A |
| |
B | B |
| |
| FRONT |
| |
RightLeft
RightLeft
Front speakers A
Front speakers B
One or two speaker systems can be connected to this unit. If you connect only one speaker system, connect it to either the SPEAKERS A or B terminals.
IMPEDANCE SELECTOR switch (Canada model only)
Be sure to switch this only when the power of this unit is turned off. Select the position proper for the use of your front speakers.
One or two center speakers can be connected to this unit. If you cannot place the center speaker on or under the TV, it is recommended to use two center speakers and place them on both sides of the TV to orient the center sound at the center position.
For connecting two center speakers, follow the method shown below.
REAR
CENTER
A OR B:USE 4ΩMIN.
/SPEAKER A 
B:USE 8ΩMIN.
/SPEAKER
A OR B:USE 8ΩMIN.
/SPEAKER
IMPEDANCE
SELECTOR
SELECTEUR
D’IMPEDANCE
When using one pair of front speakers;
•If the impedance of each speaker is
8Ω or higher, set to right ( 
).
•If the impedance of each speaker is 4Ω or higher, but lower
than 8Ω , set to left ( 
).
When using two pairs of front speakers;
The impedance of each speaker must be 8Ω or higher.
Set this switch to left ( |
| ). |
CD
DUAL
SINGLE
Center speaker Center speaker
FRONT LEVEL switch (Australia model only)
Normally set to “0 dB”. If desired, you can decrease the output level at the FRONT SPEAKERS terminals by 10 dB by setting this switch to
l | l0 dB 0 dB |
| FRONT |
| LEVEL |
8