Yamaha RX-V590 How to Connect:

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire of the proper gauge, cut as short as possible. If the connections are faulty, no sound will be heard from the speakers. Make sure that the polarity of the speaker wires is correct, that is, + and – markings are observed. If these wires are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do not let them touch the metal parts of this unit as this could damage this unit and/or speakers.

Note

Use speakers with the specified impedance shown on the rear of this unit.

For connecting to the FRONT SPEAKERS terminals

English

For connecting to the REAR and CENTER SPEAKERS terminals

Red: positive (+)

Black: negative (–)

2

1

3

➀Unscrew the knob.

➁Insert the bare wire. [Remove approx. 5mm (1/4”) insulation from

the speaker wires.]

➂Tighten the knob and secure the wire.

Red: positive (+)

Black: negative (–)

		➀Press up the tab.
		➁Insert the bare wire.
		[Remove approx. 5mm
➀		(1/4”) insulation from
		the speaker wires.]
	➂	➂Release the tab and
		secure the wire.

<U.S.A., Canada and General models only>

Banana Plug connections are also possible. Simply insert the Banana Plug connector into the corresponding terminal.

➁

9