PRESET REMOTE CONTROL

Advanced Information

■Setup codes

You can set the code for the manufacturer of your component in each position of the selector dial.

1Turn on your component to be used.

2 Set the selector dial to the desired position for the component (TAPE/MD, CD, DVD/LD, etc.).

3Press i (right) and j (left)

at the same time for about four seconds.

The indicator flashes twice.

4 Use the numeric buttons to enter the four-digit manufacturer’s code for the component to be used. Make sure that the indicator flashes twice.

If the indicator does not flash or flashes rapidly several times, repeat step 3 and re-enter the code.

5Press AV POWER (or any other button) on the remote control to check if you have set the code correctly.

If your component cannot be controlled with the remote control, try setting another code for the same manufacturer.

Notes

•You can set only one code for one position.

•In the DVD/LD and DVD MENU positions:

Be sure to set the selector dial to the DVD/LD position before entering the code for the DVD/LD player. The code set in the DVD/LD position is also simultaneously set in the DVD MENU position. You cannot set the code for a DVD player when the selector dial is set to the DVD MENU position.

•If your component does not respond to any of the codes listed for the manufacturer, use the original remote control supplied with your component.

■To use a second (and third) VCR

You can control a second (and third) VCR in the CBL/SAT and DVD MENU positions if a cable TV or satellite tuner, or DVD player is not being used.

Note

•If you want to control a second (and third) VCR in the DVD MENU position, you must set the code for an LD player in the DVD/LD position.

1Turn on the VCR to be used.

2 Set the selector dial to the

CBL/SAT or DVD MENU position.

3Press i (right) and j (left)

at the same time for about four seconds.

The indicator flashes twice.

4 Use the numeric buttons to enter the four-digit code for the second (and third) VCR. Make sure that the indicator flashes twice.

If the indicator does not flash or flashes rapidly several times, repeat step 3 and re-enter the code.

5Press AV POWER (or any other button) on the remote control to check if you have set the code correctly.

If the VCR cannot be controlled with the remote control, try setting another code for the same manufacturer.

48