TROUBLESHOOTING

 

 

 

 

 

SYMPTOM

CAUSE

REMEDY

Refer to

page

 

 

 

 

 

 

 

 

 

No sound from the

The sound output level of the center speaker is

Raise the level of the center speaker.

39

center speaker.

set to minimum.

 

 

 

 

 

 

 

 

 

“CENTER SP” on the SET MENU is set to the

Select the LRG or SML position.

36

 

 

NONE position.

 

 

 

 

 

 

 

 

 

Incorrect DSP program is selected.

Select the appropriate program.

32, 33, 34

 

 

 

 

 

 

 

The source encoded with Dolby Digital or DTS

 

 

 

does not have a center channel signal.

 

 

 

 

 

 

 

No sound from the rear

The output level of the rear speakers is set to

Raise the output level of the rear speakers.

39

speakers.

minimum.

 

 

 

 

 

 

 

 

 

A monaural source is being played with the PRO

Select another DSP program suitable for the

34

 

 

LOGIC/Normal or PRO LOGIC/ENHANCED

monaural source.

 

 

 

program.

 

 

 

 

 

 

No sound from the

“BASS OUT” on the SET MENU is set to the

Select the BOTH position.

36

subwoofer.

SW or MAIN position when playing a 2-channel

 

 

 

 

source.

 

 

 

 

 

 

 

 

 

The source does not contain low bass signals

 

 

 

(below 90 Hz).

 

 

 

 

 

 

A “humming” sound can

Incorrect cable connections.

Firmly connect the audio plugs. If the problem

13, 14

be heard.

 

persists, the cables may be defective.

 

 

 

 

 

 

 

 

No connection from the turntable to the GND

Make the GND connection between the

13

 

 

terminal.

turntable and this unit.

 

 

 

 

 

The volume level is low

The record is being played on a turntable with an

The turntable should be connected to the unit

13

while playing a record.

MC cartridge.

through the MC head amplifier.

 

 

 

 

 

The volume level cannot

The component connected to the TAPE/MD

Turn on the power to the component.

be increased, or the

OUT (REC) terminals of this unit is in the

 

 

sound is distorted.

standby mode.

 

 

 

 

 

 

 

The sound effect cannot

It is not possible to record the sound effect by a

 

31

be recorded.

tape deck or MD recorder connected to the

 

 

 

 

TAPE/MD OUT (REC) terminals of this unit.

 

 

 

 

 

 

The DVD/LD, TV/digital TV

The DVD/LD player, TV/digital TV or cable

Make additional connections between the

14

or cable TV/satellite tuner

TV/satellite tuner is connected to the unit only

analog terminals.

 

source cannot be

through the digital terminals.

 

 

recorded by a tape deck,

 

 

 

MD recorder or VCR

 

 

 

connected to this unit.

 

 

 

 

 

 

 

Adjusting this unit by

“MEM. GUARD” on the SET MENU is set to

Set “MEM. GUARD” to the OFF position.

38

using SET MENU, TIME/

the ON position.

 

 

LEVEL or TEST cannot

 

 

 

be performed.

 

 

 

 

 

 

 

 

APPENDIX

English

51