Connections

Connecting speakers

Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, this unit cannot reproduce the input sources accurately.

Caution

Before connecting the speakers, make sure that this unit is turned off (see page 25).

Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This could damage this unit and/or the speakers. If the speaker wires are short-circuited, “CHECK SP WIRES” appears in the front panel display when you turn on this unit.

Use the magnetically shielded speakers. If this type of speaker still creates interference with the monitor, place the speakers away from the monitor.

If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6MIN” before using this unit (see page 25). 4 ohm speakers can be also used as the front speakers (see page 94).

Note

A speaker cord is actually a pair of insulated cables running side by side. Cables are colored or shaped differently, perhaps with a stripe, groove or ridge. Connect the striped (grooved, etc.) cable to the “+” (red) terminals of this unit and your speaker. Connect the plain cable to the “–” (black) terminals.

PREPARATION

EXTRA SP terminals

Connect the alternative front speaker system (FRONT B), presence speakers or Zone 2 speakers.

To select the function of the speakers connected to the EXTRA SP terminals, set the “EXTRA SP Subwoofer ASSIGN” parameter in “SOUND MENU” (see page 72).

y

You can also select the function of the speakers connected to the EXTRA SP terminals in “AUTO SETUP” (see page 29).

PRE OUT

SUBWOOFER

SPEAKERS

FRONT B/ZONE2/

 

FRONT A

CENTER

SURROUND

SURROUND BACK/

PRESENCE

 

 

 

 

 

BI-AMP

R EXTRA SP L

R

L

R

L

R

SINGLE L

Center speaker

Right Left

Surround speakers

Right Left Front speakers (FRONT A)

Right Left Surround back speakers

When you use a single surround back speaker, connect the speaker to the left SURROUND BACK terminal (SINGLE).

English

13 En