4Press Dl/ hto select the desired setting for “EXTRA SP ASSIGN” and then press Dn.
Extra speaker assignment
EXTRA SP ASSIGN
Selects the function of the speakers connected to the EXTRA SP terminals.
Choices: FRONT B, ZONE2, PRESENCE, NONE
•When you use the alternative front speaker system (see page 38)
Select “FRONT B”.
•When you use the Zone 2 speakers (see page 91)
Select “ZONE2” to set the function of the speakers to the Zone 2 speakers. This unit drives the Zone 2 speakers by using the internal amplifier.
•When you use the presence speakers (see page 12)
Select “PRESENCE” to set the function of the speakers to the presence speakers.
•When you do not use the EXTRA SP terminals
Select “NONE” to deactivate the EXTRA SP terminals.
Note
If you select “ON” in
5Press Dl/ hto select “SETUP” and then press Dn.
Choices: AUTO, RELOAD, UNDO, DEFAULT
•Select “AUTO” to automatically run the entire “AUTO SETUP” procedure.
•Select “RELOAD” to reload the last “AUTO SETUP” settings and override the previous settings.
•Select “UNDO” to undo the last “AUTO SETUP” settings and restore the previous settings.
•Select “DEFAULT” to reset the “AUTO SETUP” parameters to the initial factory settings.
Notes
•“RELOAD” or “UNDO” is available only when you have previously run “AUTO SETUP” and confirmed the results.
•“RELOAD” or “UNDO” is not available when you change the setting of
Optimizing the speaker setting for your listening room
6Press Dl/ hto select the desired setting of “EQ”.
Parametric equalizer type EQ
Parametric equalizer adjusts the level of the specified frequency bands. This unit automatically selects the crucial frequency bands for the listening room and adjusts the level of the selected frequency bands to create a cohesive sound field in the room. You can select the type of the parametric equalizer adjustment from the following choices.
Choices: NATURAL, FLAT, FRONT
•Select “NATURAL” to average out the frequency response of all speakers with higher frequencies being less emphasized. Recommended if the FLAT setting sounds a little harsh.
•Select “FLAT” to average the frequency response of all speakers. Recommended if all of your speakers are of similar quality.
•Select “FRONT” to adjust the frequency response of each speaker in accordance with the sound of your front speakers. Recommended if your front speakers are of much higher quality than your other speakers.
7Press Dnto select “START” and then press
DENTER to start the setup procedure.
This unit starts the auto setup procedure. Loud test tones are output from each speaker during the auto setup procedure. Once all items are set, the “AUTO:RESULT” display appears in the OSD.
Notes
•During the auto setup procedure, do not perform any operation on this unit.
•We recommend that you get out of the room while this unit is in the auto setup procedure. It takes approximately 3 minutes for this unit to complete the auto setup procedure.
PREPARATION
English