Yamaha RX-V863 61 En, All Channel Search mode, Direct number access mode, Category Search mode

Before performing the following operations, set the operation mode selector on the remote control to FSOURCE and then press 4XM.

■All Channel Search mode

1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “ALL CH

SEARCH”.

2Press EPRESET/TUNING/CH l / h (or

8PRESET/CH k / n) repeatedly to search for a channel within all channels.

y

•You can search for a channel quickly by pressing and holding

EPRESET/TUNING/CH l/ h(or 8PRESET/CH k/ n).

•To display the XM Radio ID number displayed in the front panel display, select channel “0”.

XM Satellite Radio tuning

3Press EPRESET/TUNING/CH l/ h (or

8PRESET/CH k/ n) repeatedly to change the preset channel number (1 to 8).

y

You can also select the preset channel number directly by pressing the numeric buttons (1 to 8) (6).

■Direct number access mode

1Press ISRCH MODE on the remote control repeatedly to select “ALL CH SEARCH” or “CAT SEARCH”.

2Press the numeric buttons (6) to enter the desired three-digit channel number.

For example, to enter the number 123, press the numeric buttons (6) as shown below.

■Category Search mode

1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “CAT SEARCH”.

2Press DCATEGORY (or 8A-E/CAT.l / h) repeatedly to change the channel category.

3Press EPRESET/TUNING/CH l / h (or

8PRESET/CH k / n) repeatedly to search for a channel within the selected channel category.

y

You can search for a channel quickly by pressing and holding

EPRESET/TUNING/CH l/ h(or 8PRESET/CH k/ n).

■Preset Search mode

Prior to selecting a preset channel in the Preset Search mode, you must preset XM Satellite Radio channels. For details, see “Setting the XM Satellite Radio preset channels” on page 62.

y

The initial factory setting of all preset channels (A1 to E8) is “001 Preview”.

1Press BSEARCH MODE (or ISRCH MODE) repeatedly to select “PRESET

SEARCH”.

2Press DCATEGORY (or 8A-E/CAT.l / h) repeatedly to change the preset channel group (A to E).

1 2 3

y

•To enter a one-digit or two-digit channel number, press the numeric buttons (6) on the remote control and then press HENT to confirm the input number.

•Instead of pressing HENT to tune into the channel immediately, you can wait a few seconds until this unit confirms the entered channel number.

•Pressing a button other than the numeric buttons (6) or HENT cancels the Direct Number Access mode procedure.

OPERATION BASIC

English

61 En