54 SPX2000—Owner’s Manual
■Fine parameters
Chorus, Tremolo (CLASSIC bank)
These effects are based on earlier models of the SPX series. These effects have a simpler parameter structure than the corre-
spondingly-named effects of the PRESET bank.
Each aspect of the sound is controlled by the following effect parameters.
Modulation signal: MOD.FREQ., AM DEPTH, PM DEPTH
Output level: OUT LVL, MIX BAL.
Parameter details
■Basic parameters
Effect list
The following table shows the default parameter values for the effects belonging to the Chorus and Tremolo types (CLASSIC
bank).
Symphonic (CLASSIC bank)
This effect is based on earlier models of the SPX series. This effect has a simpler parameter structure than the correspond-
ingly-named effects of the PRESET bank.
Each aspect of the sound is controlled by the following effect parameters.
Modulation signal: MOD.FREQ., DEPTH
Output level: OUT LVL, MIX BAL.
Parameter details
■Basic parameters
Effect list
The following table shows the default parameter values for the effect belonging to the Symphonic type (CLASSIC bank).
No. Effect name MIX BAL. OUT LVL LSH G LSH F EQ G EQ F EQ Q HSH G HSH F
70 TREMOLO
100% 100% 0.0 dB 125 Hz 0.0 dB 1.00 kHz 10.0 0.0 dB 10.0 kHz
SYNC NOTE TEMPO
OFF —
Parameter name Range Explanation
MOD. FRQ 0.1—40.0 Hz Speed of modulation (AM, PM). Increasing this value will make the modulation repeat at a shorter
interval.
PM DEPTH 0—100% Pitch modulation (PM) depth. Increasing this value will make the pitch modulation deeper.
AM DEPTH 0—100% Amplitude modulation (AM) depth. Increasing this value will make the volume modulation
deeper.
OUT LVL 0—100% Output level after the original sound and effect sound have been mixed.
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
MIX BAL. 0—100% Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
No. Effect name MOD.FRQ PM DEPTH AM DEPTH OUT LVL MIX BAL.
11 CHORUS A 0.2 Hz 100% 55% 100% 100%
12 CHORUS B 0.3 Hz 96% 10% 100% 100%
14 TREMOLO 6.0 Hz 50% 50% 100% 100%
Parameter name Range Explanation
MOD. FRQ 0.1—40.0 Hz Speed of modulation. Increasing this value will make the modulation repeat at a shorter interval.
DEPTH 0—100% Modulation depth. Increasing this value will make the modulation deeper.
OUT LVL 0—100% Output level after the original sound and effect sound have been mixed.
Decrease this value if you want to lower the output. At a setting of 0% there will be no output.
MIX BAL. 0—100% Balance between the original sound and effect sound. At a setting of 0% only the original sound
will be output; at a setting of 100% only the effect sound will be output.
No. Effect name MOD.FRQ DEPTH OUT LVL MIX BAL.
15 SYMPHONIC 0.7 Hz 94% 100% 100%