y

•Aim the TV remote control toward the top of TV remote signal receptor.

•You can operate the TV remote control by using the TV remote signal receptor even if the unit is in standby mode.

•Some TV remote controls may not work.

•You can attach the TV remote signal receptor in an area where there are projections, such as the rear of speaker stand, etc.

•Clean the attachment area on the speaker, using a soft, dry cloth, such as one for cleaning glasses.

•Clean the signal receiver and signal emitter of the TV remote signal receptor, using a soft, dry cloth, such as one for cleaning glasses.

Attaching the speaker to a wall
Installing the speaker using the keyholes

You can attach the speaker to a wall using commercially available screws (#8, Diameter: 4 mm (3/16”)).

When installing the speaker on a wall, all installation work must be performed by a qualified contractor or dealer. The customer must never attempt to perform this installation work. Improper or inadequate installation could cause the speaker to fall, resulting in personal injury.

1 Attach the supplied mounting template on a wall and mark the holes of the mounting template.

Tapes or thumbtacks

Mark

2 Remove the mounting template and then install screws (not supplied) at the marks.

7 to 9 mm

4 mm (#8)

(1/4” to 3/8”)

 

Minimum

20 mm (3/4”) 2 to 4 mm (1/16” to 3/16”)

Placing

3 Hang the speaker on the screws using the keyholes on the back of the speaker.
Installing the speaker using the screw holes

You can also use the screw holes on the rear of the speaker for installing the speaker using a commercially available rack etc.

38.5 mm (1-9/16”)

256 mm

 

 

(10-1/16”)

 

 

Screw holes

 

 

Hole depth: 14 mm (9/16”)

 

 

Diameter: 6 mm (1/4”)

 

 

14 mm (9/16”)

 

Screw

 

 

(M6)

Screw

 

 

NS-BR301

 

hole

Rack etc.

 

 

 

 

Min 7 mm (1/4”)

Notes

•Attach the speaker to a rack or wall. Do not attach the speaker to a wall that is made of weak materials such as plaster or veneered woods. Doing so may cause the speaker to fall.

•Use commercially available screws that can support the weight of the installation.

•Make sure you use specified screws to attach the speaker. Using clamps other than specified screws, such as short screws, nails, or two-sided tape, may cause the speaker to fall.

•When connecting the speaker, fix the speaker cables in place where they will not become loose. If your foot or hand accidentally gets caught on a loose speaker cable, the speaker may fall.

•After attaching the speaker, check that the speaker is fixed securely. Yamaha will bear no responsibility for any accidents caused by improper installations.

PREPARATION

English

7 En