Yeoman YM-CL5W, YM-CL8W Fitting And Removal Of The Firebricks, Fitting And Removal Of The Baffle

INSTALLATION INSTRUCTIONS

3.FITTING AND REMOVAL OF THE FIREBRICKS

3.1Remove the firebricks as part of the routine maintenance. This can be carried out without the use of tools.

3.2Allow the appliance to cool fully before removing firebricks.

3.3Take care when handling, as bricks can become fragile after use. Life span depends on the type of fuels burnt and the level of use.

—Replace damaged bricks as soon as possible.

3.4When removing the firebricks make note of the position of the chamfered edges and cutouts.

Chamfered edge

Chamfered edge

Cutouts PR8737

—Replace in the same orientation.

4.FITTING AND REMOVAL OF THE BAFFLE

4.1The appliance is fitted with a baffle in the top of the firebox to maintain efficient combustion.

Support Pin

PR8754

4.2Allow the stove to cool fully before removing the baffle system.

4.3To remove the baffle:

—Remove the log guard from the stove for access.

—Lift the front edge of the baffle to clear the support bars.

—Pull the baffle forward to disengage the rear edge from the location above air inlet holes.

—Rotate the baffle to remove from the firebox through the door opening.

Front

PR7076

—Replace in reverse order.

4.6Remove and clean the baffle system to ensure the flue ways are clear of soot and debris and to ensure the safe, efficient operation of the stove. The frequency of cleaning will depend on the stove operating conditions.

4.7The baffle system is designed to give safe and efficient operation of the stove. Replace any damaged baffle immediately.

4.8Do not modify the baffle system.

5. REMOVAL OF RIDDLING MECHANISM

To maintain good working condition the multi-fuel grate can be removed for cleaning.

5.1Remove ashpan, log guard, baffle and firebricks (see preceding sections).

5.2remove centre grate (see Diagram 7).

Centre grate PR8845

5.3Remove main grate (see Diagram 8).

21