York K3EU120, K2EU060, K4EU090, K3EU180 UNIT DIMENSIONS KEU090, UNIT CLEARANCES KEU090, Accessories

036-21300-002-A-0905

			
			
+./#+/54
2EMOVED ONLY WHEN			!)2
%LECTRIC (EATA!CCESSORY			/54
			
IS USED
			





	!)2
	).





 +./#+/54 &/2/0/7%277)2).' "ACKA0ANEL

$O NOTOREMOVE THIS KNOCKOUTCWHEN THE UNIT IS EQUIPPEDPWITH AN %LECTRIC (EAT !CCESSORYS2EFERYTO DETAIL OF THEE(EATER !CCESSORY FOR POWER WIRING ACCESS OPENING

 (/,% 7"53().' &/2/#/.42/, 7)2).' "ACKC0ANEL

 

		 
		
		
	",/7%2 -/4/2
	!.$.$2)6%%
	!##%33 0!.%,
	4HISSSIDE ONLY
	(/,% 7)4( '2/-
	-%44&/2//$
	,)15)$ ,).%
		

		(/,% 7)4( '2/-
		-%44&/2//$
	 35#4)/. ,).%
		
		
		/$ $2!).
		#/..-USTSBE
		TRAPPED

&),4%2 !##%33 0!.%,

7HENEUNIT IS INSTALLED IN

AAHORIZONTAL POSITIONDO NOTOBLOCK THIS AREARWITH REFRIGERANTAPIPING

All dimensions are in inches. They are subject to change without notice. Certi- fied dimensions will be provided upon request.

FIGURE 2 - UNIT DIMENSIONS KEU090 & 120

ACCESSORIES

•ELECTRIC HEATER - Add 14-1/4” to unit height when used.

•SUPPLY AIR PLENUM - Add 27-1/2” to unit height when used.

•BASE - Add 20” to unit height when used.

TABLE 19: UNIT CLEARANCES KEU090 & 120

MINIMUM CLEARANCES	090-120
Side with RETURN AIR opening	24”
Side with SUPPLY AIR opening1	24”
Side with PIPING CONNECTIONS2	36”
Side opposite with PIPING CONNECTIONS	12”
Side with access for both POWER & CONTROL	-
WIRING3,
Bottom4	-

1.Overall dimensions of the unit will vary if an electric heater, a supply air plenum or a base is used.

2.This dimension is required for removal of the coil. Only 26” is required for normal service.

3.Although no clearance is required for service and oper- ation, some clearance may be required for routing the power and control wiring.

4.Allow enough clearance to trap the condensate drain line.

Unitary Products Group 17