MICROMIX
ii.To adjust for deficiencies in the speaker system’s high frequency and bass response, the M608 also has a
iii.The third use of the graphic equalizer is to adjust the sound character for artistic reasons. The frequencies are adjusted until the sound feels best to the musicians.
SPEAKON™ Pin 1+/1–
Configuration
SPEAKER OUTPUT | Phantom | SPEAKER OUTPUT |
|
|
| ||||
| Power |
|
| DISCONNECT POWER | |||||
|
|
| |||||||
CHANNEL B |
|
|
|
|
| CHANNEL A |
|
| DEBRANCHER L’APPEREIL |
|
|
|
|
|
|
|
|
| BEFORE SERVICING! |
|
|
|
|
|
|
| 2 x 3 0 0 W a t t P608o w e r e d M i x e r | AVANT D’ENLEVER | |
250 Watts |
| on off | 250 Watts | LES COUVERCLES! | |||||
MAX |
|
|
|
|
| MAX |
|
| THIS UNIT MUST BE GROUNDED! |
CET APPAREIL DOIT ETRE MIS Á TERRE!
MODEL TYPE:YS1088
POWER
ONCircuit Breaker
4 0 8 0 0 0 1
DESIGNED & MANUFACTURED BY YORKVILLE SOUND • TORONTO, CANADA
M608 Rear Panel
1. Power Amplifiers
Each of the M608 dual power amplifiers has two
WARNING: Do not obstruct the flow of air around the vents on the rear of the M608, this may cause the power amplifier to overheat. The amplifier will start to reduce its power output in order to keep running. In extreme cases it may be forced to shut down. After the M608 cools down, operation will be restored automatically This con- dition should not occur if adequate ventilation is provided at the back of the unit.
2. Power Switch and Breaker
The Power switch and circuit breaker are located on the rear panel. If the circuit breaker trips during use, wait a few minutes (to cool), then push in to reset. The circuit breaker can trip if the amplifier is too heavily loaded with long periods of continuous tones (such as feedback). If the circuit breaker trips immediately after being reset, take the unit to your Yorkville dealer for service.
7