INSTALLATION

It is important to use the proper screws.

To secure the StarGate to the frame, use four Pan- head Phillips screws and washers on each side, for a total of eight.

NOTE: All four screw

NOTE: Installing the

holes in the

StarGate

RETMA rail

requires two

must be visible

people, one to

through the

hold the unit,

four screw holes

while the other

on both sides of

secures the unit

the StarGate.

with screws.

If not, move the

 

StarGate up or

 

down until all

 

four holes are

 

visible.

 

One person hold the right side of the StarGate, while the other person secures the fi rst screw in the upper left corner of the unit.

Before inserting any additional screws, check to see that all the remaining seven holes in the StarGate line up with the screw holes in the RETMA rails.

Then secure the remaining seven screws. Do NOT tighten the screws.

Test the fi t by opening and closing the StarGate several times.

For a fi nal adjustment, make sure that the back plate is fl ush against the RETMA rail and the back plate is square to the RETMA rails.

Once positioned, tighten down the screws.

8

Test the adjustment by opening and closing the StarGate display several times.

If there is any binding, check for alignment and repeat the previous step.

Doc# 27-0027UM Rev 1.0 Issued 10/04