Graphic F |
| |
5 mm Hardwood strip |
| |
40 | Additional pieces | |
| ||
100 | of timber should run | |
from front to back | ||
|
Front view
Where the appliance has been raised by mounting onto a wooden base provided by the installer. The material used to construct the base should have anon slip surface, be water repellent and if possible be one solid piece.
If it is not possible to use one solid piece, due to the additional height required, ensure that any additional strips of timber are glued and screwed to the underside of the base (see Fig. F).
Graphic G
| ||
| 490 | |
95 |
| |
50 | Front edge | |
Top view | ||
|
Drill four fixing holes see Fig. G
Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow.
The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appli- ance feet.
30
Graphic H
Hardwood strip 5 mm x 25 mm
5 x 25 x 605
490
600-605
Fix the base firmly to the floor using four ap- propriate countersunk screws (see Fig. H). With the appliance installed adjust all four feet ensuring the machine is stable, and a clearance of approximately 5 mm is left be- tween the top of the machine and the under- side of the worktop.
A final check for stability should be carried out with the machine on spin with a load, this will identify the need for any further fine ad- justment to the feet.
A strip of beading approximately 605 mm W, x 5 mm H, x 25 mm D must be screwed down into the base directly in front of the machine’s feet, this will provide additional security.
If required an additional door magnet, part number
www.zanussi.com
