38 mm (1.5”)
standpipe
diamater
30 cm (12”)
The drain hose may be extended to a maxi-
If the outlet spigot has not been used before, remove any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to prevent waste from the sink entering the appliance.
mum of 4 metres. An additional drain hose and joining piece is available from your local Service Force Centre. The joining piece must have an internal diameter of 18 mm.
Min. 60 cm (23.6”) Max. 90 cm (35.4”)
If your drain hose looks like this (see beside) you do not require the “U” piece”. Just push the hose firmly in to the standpipe.
2. Onto a sink outlet spigot.
Loop
If you intend to drain the hose from the ma- chine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U - Piece” supplied.
In the interest of the environment
The appliance should be connected to the FOUL drainage system, the water will then be taken to a sewage works for treatment before being discharged safely into a river.
It is essential that these appliances are not con- nected to the surface water drainage system as this water is discharged directly into a river or stream and may cause pollution.
If you require any further advice please contact your local water authority.
SHOWER
SINK TOILET
BATHBIDET
WASHING
MACHINE DISHWASHER
RAINWATER
SURFACE WATER | FOUL DRAIN | ||||||
FOUL SEWERS | |||||||
DR | AINS & SEWE | RS | |||||
|
| UNTREATED | SEWAGE TREATMENT |
|
| ||
|
|
|
| ||||
|
| DISCHARGE | WORKS |
|
| ||
|
|
|
| TREATED DISCHARGE |
|
| |
|
|
|
|
|
| ||
|
|
|
|
|
| ||
|
| RIVER | RIVER | ||||
www.zanussi.com | 27 |
|
