After removing all the packaging, carefully lay machine on it's back to remove the polystyrene base from the bottom.
Unscrew the three bolts with the sup- plied spanner.
Remove the power supply cable and the hose from the hose holders on the rear of the appliance.
Slide out the relevant plastic spacers.
Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incor- porate a self locking nut, but the machine MUST be level and stable. If necessary, check the setting with a spirit level.
Any necessary ad- justment can be made with a spanner.
Accurate levelling prevents vibration, noise and displacement of the machine during operation.
Caution! Never place cardboard, wood or
similar materials under the machine to compensate for any unevenness in the floor. After having levelled the appliance, tighten the lock nuts.
Raising the appliance
Suspended wooden floors are particularly sus- ceptible to vibration.
Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the in- struction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units.
www.zanussi.com
To help prevent vibration we recommend you place a waterproof wood panel, at least 15 mm thick under the appliance, secured to at least 2 floor beams with screws, the wood panel must extend beyond the front feet.
If possible install the appliance in one of the corners of the room, where the floor is more stable.
Water inlet
25
