Caution!
•This appliance must be connected to a cold water supply.
•Before connecting up the appliance to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush out any debris that may have collected.
•Do not use the hose from your previous appliance to connect to water supply.
The inlet hose is supplied with the appliance and can be found inside the machine drum.
35° | 45° |
Open the porthole and extract the inlet hose. Connect the appropriate end of the hose to the appliance with the angled connection as showed in the picture. Do not place the in- let hose downwards. Angle the hose to the left or right depending on the position of your water tap.
After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks .
Connect the other end of the inlet hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.
Caution! The inlet hose must not be lengthened. If it is too short and you do not
wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use.
Warning! Installation should comply with local water authority and
building regulations’ requirements. The appliance must be connected to a cold water supply.
A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance.
If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.
There should be a minimum vertical distance of
5.02m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage system us- ing one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied.
“U” piece supplied
Place the drain hose into your standpipe, which should have an internal diameter of ap- proximately 38 mm thus ensuring there is an air break between the drain hose and stand- pipe.
When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level.
26 | www.zanussi.com |
