INSTRUCTIONS FOR THE INSTALLER
SAFETY ADVICE
Before installation ensure that the local distribution conditions (gas type and pressure) and the same as those stated on the rating plate of the appliance.
This appliance must be installed only in a room with good ventilation.
This appliance must not connected to a flu. It has to be installed and connected in accordance with the rules in force. Special attention should be paid to the applicable disposal concerning ventilation.
The adjacent furniture panels have to be heat proof or protected by such material.
The adjusting conditions of this appliance are mentioned on the rating plate.
Connection to gas supply.
Check that the gas flow and the diameter of the supply pipe is sufficient to supply all the appliances of the installation.
Check that all connections are tight.
Install an accessible and visible gas tap to isolate the appliance.
This appliance utilises a threaded ½” gas cylindrical male fitting according to
To connect the appliance to the gas supply with a flexible rubber hose, a supplemental hose nipple fitting is needed which is supplied with the appliance.
-Installation of flues and ventilation for gas appliances of rated input not exceeding 60 kW (1st, 2nd and 3rd family gases) – Part 2 Specification for installation of ventilation for gas appliances – BS 5440;
-Gas burning appliances – Part 3 Domestic cooking appliances burning gas – BS 5386;
-Specification for installation of low pressure gas pipe work of up to 20mm (R1) in domestic premises (2nd family gas)
– BS 6891;
-Pipe threads for tubes and fittings where
-Flexible hoses, end fittings and sockets for gas burning appliances – BS 669;
-Installation of domestic gas cooking appliances (1st, 2nd and 3rd family gases) – BS 6172: 1990;
22
An adapter to covert the Gas Inlet from ½” BSP parallel thread to ½” BSP tapered (conical) thread is supplied, including washers. Ensure this is correctly fitted on installation.
