INSTALLATION Flexible Pipe Installation.

1. FITTING THE APPLIANCE AND CABINET

It is recommended that a 3/8, 1100mm long angled bayonet flexible hose (BFS) and a ½" straight socket
(BFS) be used for the installation. However any approved hose of the right length can be used.
IMPORTANT: Flexible tubing used must comply with B.S. 669 current editions L.P.G. flexible connections
must be of a type suitable for L.P.G. and capable of operation up to 50mbar and carry a red stripe, band or
lable.
NOTE:Only liquid sealants can be used in threaded gas connections. Do not use P.T.F.E. tape.
1 Make suitable arrangements for gas and electric supplies into the installation site. Preferably a junction
box or 3 pin earth socket should be situated at the back of the cabinet below the oven.
2 The electrical connection to the appliance is at the rear bottom right hand side, the junction box or socket
should be positioned accordingly.
3 Fit the cabinet as Fig.1, making sure that it is level.
4 When unpacking the appliance keep it on it's polystyrene base until it is put into the cabinet to avoid
damage.
5 Remove the oven and grill doors
i) Open door fully.
ii) Engage both hinge locking pins (See Fig. 2).
iii) To remove the door, clear the hinges by raising the door slightly whilst pulling towards you.
6 Remove the fascia panel .
i) Remove the gas control knobs, springs, bezels and
timer control knobs.
ii) Remove the four screw (two each side) which are
visible on the underside of the fascia. Fig.3.
iii) Tilt the bottom of the fascia panel out over. Withdraw
the fascia panel by moving it down over to disengage it
from the top fixing lugs. Take care not to lose the two
rubber grommets from the timer.
NOTE The thermostat and grill discs will remain attached to the
fascia panel. When refitting the control knobs and bezels, the
drive pins on the rear of the bezel must first be located in the disc
carrier. The knob and spring can now be fitted onto the control
spindle. To prevent the top fascia panel mounts becoming slack, it
may be necessary to adjust the top fixing lugs.
5
Fig.2
Fig.3
HINGE
LOCKING PIN