Zanussi ZKT6050 Residual heat HOB, To fit the top oven shelf, Top oven intelligent grill

Models: ZKT6050

1 40
Download 40 pages 41.42 Kb
Page 14
Image 14
Residual heat HOB

IMPORTANT!

Occasionally the heated areas may be seen to switch on and off when higher heat settings are being used. This is due to a safety device, which prevents the glass from overheating.

Some switching on and off when cooking at high temperatures, e.g. deep fat frying is quite normal, causes no damage to the hob and little delay in cooking times.

Excessive switching may however be caused by the use of an unsuitable saucepan or a saucepan which is smaller than the heated area. If excessive switching occurs, discontinue use of the saucepan.

Residual heat HOB

When a hob function has been switched off the residual heat indicator will remain alight to indicate that the hob is still hot. ‘ H‘ will show in the display until the appliance has cooled. If the appliance is switched off at the supply before the hob has fully cooled, the residual heat indicator will remain illuminated when the electricity is restored. This is a safety precaution.

To fit the top oven shelf

The shelf should be fitted with the straight rods uppermost on the frame and the forms towards the back of the oven.

14

To remove a shelf slide the shelf towards you until the shelf stop is reached. Tilt shelf up at the front to that the stops clear the side supports. Lift shelf clear. To install a shelf, reverse the above steps. Each shelf position has an upper and lower support.

To fit the top oven shelf WARNING!

Do not place cookware and cooking pots with rough bases e.g. cast iron on the oven door as damage to the glass may occur.

Top oven intelligent grill

Top oven intelligent grill WARNING!

CAUTION: Accessible parts may be hot when the grill is in use. Young children should be kept away.

Using intelligent grill

The oven must be switched on Using intelligent grill before setting any cooking function or programme.

Press the Oven Cavity selector Manual background until the top oven cavity indicator is illuminated.

Press the Function selector Manual background until the required setting is shown Manual backgroundManual background.

To use the grill at lower settings press the function selector Manual background untill the required setting is shown Manual backgroundManual background.

Wait 5 seconds until your choice is confirmed. The temperature will automatically set to 250°C if grilling with the door closed.

Page 14
Image 14
Zanussi ZKT6050 Residual heat HOB, To fit the top oven shelf, Top oven intelligent grill, Using intelligent grill