Installation dimensions
The opening in the cabinet must correspond to the standard dimensions. The necessary information can be found in the dimensional sketch.
·The separation between the lower surface of the hob and the parts of the furniture below it must be at least 20 mm.
·The lateral separation between the sides of the hob and the cabinet must be at least 50 mm, and must be at least 50 mm from the rear panel.
This appliance conforms to Type Y (IEC
Installation
1.Cut out the worktop according to the prescribed di- mensions (Fig.1). (Saw exactly along the scribed line.)
2.Fix according to Fig. 2
Position A must be used for
Important: The screw must be driven into the worktop as illustrated.
Avoid overtightening. Do not use electric or pneumatic screwdrivers unless they have, adjustable slipping clutches (set to
3.Check the sealing for proper fit and full contact.
4.Place the ceramic hob in the
Removing the glass- ceramic hob
1.Disconnect the appliance from the electrical sup- ply.
2.Push the hob upwands from underreath.
min. 50 mm min. 50 mm min. 50 mm
20 mm | 20 mm |
Fig.1
R5 |
Fig.2
8
1 | Catch spring | 4 | Frame |
2 | Screws | 5 | Sealing tape |
3 | Worktop | 6 | Glass ceramic plate |
166