3.Close the door.
4.Set the maximum oven temperature and let the oven operate for 1 hour.
5.Clean the oven cavity with a soft and damp sponge.
Caution! Do not attempt to clean catalytic surfaces with oven sprays, abrasive cleaners, soap or other cleaning agents. This may damage the catalytic surface.
Discolouration of the catalytic surface has no effect on catalytic properties.
Shelf Support Rails
Removing the shelf support rails
1 Pull the front of the | 2 Pull the rear shelf sup- |
shelf support rail away | port rail away from the |
from the side wall. | side wall and remove it. |
Installing the shelf support rails
Install the shelf support rails in opposite sequence.
The rounded ends of the shelf support rails must point to the front!
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the door from the appliance. The door is heavy!
Removing the oven door
1.Open the oven door as far as it goes.
2.Lift up clamping levers (A) on the two door hinges fully.
A
A
3.Close the oven door until the first position (angle approx. 45°).
45°
4.Hold of the oven door with one hand on each side and pull it away from the oven at an upwards angle.
Put the oven door with the outer side down on a soft and level surface to prevent scratches.
5.Now you can remove the inner glass panels and clean them.
To install the door follow the procedure in reverse.
The oven door has 2, 3 or 4 panels of glass (de- pends on the model)
Removing and cleaning the door glasses
1.Hold the door trim (B) on the top edge of the door at the two sides and push inwards to release the clip seal.
B
2.Pull the door trim to the front to remove it.
17