Rinse aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing, and spot and streak free drying.
The dispenser, which is positioned inside the door, holds about 110 ml of rinse aid, which is sufficient for 16 - 40 dishwashing programmes, depending upon the dosage setting.
Filling with rinse aid
1.Open the container by pressing the release button (A).
2.Add the rinse aid until the container is completely full. The maximum level for filling is indicated by "max".
●If you are using dishwasher detergent that already contains rinse aid, it is necessary to deactivate the dosage of rinse aid, in order to avoid a double dosage.
Deactivation/activation of the dosage of rinse aid
(The dishwasher must be switched off)
Factory setting: dosage of rinse aid activated
When the dosage of rinse aid has been deactivated, the rinse aid indicator light on the control panel is automatically deactivated.
BR07 |
BR14 |
1. Press the On/Off push button. The On/Off indicator light |
illuminates (setting mode). |
If a programme push button indicator light is on, this means |
that a washing programme has been set. The programme |
must be cancelled: press simultaneously the function push |
buttons 2 and 3 for about 2 seconds. |
All the indicator lights will turn off (except for the On/Off |
indicator light and eventually salt and rinse aid indicator |
lights) indicating that the setted programme has been |
cancelled and the machine is now in setting mode. |
2. Press simultaneously function push buttons 2 and 3, until |
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash.
Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage).
| the indicator lights of the function push buttons 1, 2 and 3 |
| start flashing. |
3. | Press the function push button 2, the indicator lights of |
| function push buttons 1 and 3 turn off while the indicator |
| light of the function push button 2 goes on flashing, at the |
| same time the indicator light End of cycle illuminates |
| indicating that the dosage of rinse aid is active. |
4. | To deactivate the inflow of rinse aid, press the function push |
| button 2 again, the indicator light End of cycle turns off, |
| indicating that the dosage of rinse aid has been deactivated. |
5. | To memorise the operation, switch off the dishwasher by |
| pressing the On/Off push button or wait about 60 seconds |
| after which the dishwasher will automatically return to |
| setting mode. |
The dose is factory set in position 4.
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades.
BR09 |
To activate the dosage of rinse aid follow the above instructions until the indicator light End of cycle illuminates.
Top up the rinse aid when the indicator light on the control panel illuminates.
7
