2.Insert one end of the media hanger into one of the media supply guides (refer to Figure 4).
3.Place the roll of media onto the media hanger.
4.Place the second media supply guide onto the other end of the media hanger (refer to Figure 4).
NOTES: The media roll must be centered on the media hanger. The media roll should rest against the smooth side of the media supply guides. The textured side marked “out” should face the outside of the printer. The media supply guides should just touch the edges of the roll of media; they must not cause pressure or excessive drag on the media roll.
5.Refer to Figure 5. If you are using labels, make sure the media unwinds from the top of the roll. Tags unwind from the bottom of the roll.
6.Place the media roll in the top cover (refer to Figure 6).
7.Release the printhead by pulling the printhead release lever toward you (refer to Figure 6, “1”).
8.Lift the printhead (refer to Figure 6, “2”) until you feel it “lock” into place. Be careful not to force the printhead past this position!
| Smooth Side of |
Textured | Media Supply Guide |
| |
Side | 3 |
Marked | |
"OUT" | 2 |
| 1 |
| Media |
| Hanger |
| Media |
| Supply |
| Guide |
Figure 4
6