8.Refer to Figure 13. Thread the media through the media guides.

NOTE: If the media guides must be changed to accommodate the width of the media, turn the green media guide adjuster (refer to Figure 13). The media guides should just touch, but not restrict, the edges of the media roll.

9.Continue to thread the media until it is approximately 8” (203 mm) past the peel bar (refer to Figure 13).

10.Place the media hanger into the two mounting slots (refer to Figure 14).

11.Remove approximately 6” (152.4 mm) of labels from the backing.

12.Insert the label backing into the peel-off feed slot (refer to Figure 15). Continue to feed the label backing until it comes out of the bottom slot.

Media

Guides

Media

Guide

Adjuster

Peel Bar

Figure 13

12