Peel-Off Mode
1.Unlatch the top cover by pressing the two green release levers (refer to Figure 10). Then, lift the top cover to expose the media compartment.
2.Insert one end of the media hanger into one of the media supply guides (refer to Figure 11).
3.Place the roll of media onto the media hanger.
4.Place the second media supply guide onto the other end of the media hanger (refer to Figure 11).
NOTES: The media roll must be centered on the media hanger. The media roll should rest against the smooth side of the media supply guides. The textured side marked “out” should face the outside of the printer. The media supply guides should just touch the edges of the roll of media; they must not cause pressure or excessive drag on the media roll.
5.Place the media roll in the top cover (refer to Figure 12).
6.Release the printhead by pulling the printhead release lever toward you (refer to Figure 12, “1”).
7.Lift the printhead (refer to Figure 12, “2”) until you feel it “lock” into place. Be careful not to force the printhead past this position!
Release
Lever
Release 
Lever
Figure 10
10