Zebra Technologies T402 Replacing the Printhead

Replacing the Printhead

Refer to Figure 37.

1.Release the printhead by pulling the printhead release lever toward you.

2.Lift the printhead until you feel it “lock” into place. Be careful not to force the printhead past this position!

3.Remove the screw that secures the printhead to the upper frame.

4.Remove the printhead wire harness connector from the receptacle.

5.Insert the printhead wire harness connector into the receptacle of the new printhead. Make sure the connector is fully seated in the receptacle.

6.Correctly position the printhead into the upper frame.

7.While holding the printhead in place, reinstall the screw that secures the printhead to the upper frame.

	Screw
	Upper
	Frame
	Wire
	Harness
	Connector
	Receptacle
Screw

Printhead

Figure 37

44