8.Refer to Figure 21. Thread the media through the media guides.
NOTE: If the media guides must be changed to accommodate the width of the media, turn the green media guide adjuster (refer to Figure 21). The media guides should just touch, but not restrict, the edges of the roll
9.Refer to Figure 21. Thread the media through the cutter unit.
10.Place the media hanger into the two mounting slots (refer to Figure 22).
11.Close the printhead by pressing down at both arrows (refer to Figure 23).
12.Close the top cover and turn on the printer or press the feed button if the printer is already on (see “Auto Calibration” on page 25 for more information).
Media
Guides
Media
Guide
Adjuster
Cutter
Unit
Figure 21
18