Zenith H20H52DT, HW20H52DT Antenna Hook Up, Connect an off-air antenna to the HealthView TV

Antenna Hook Up

Connect an off-air antenna to the HealthView TV.

1

2

3

Locate the Antenna/Cable jack on the back of the HealthView TV.

Connect the antenna wire that runs from		TV Back
the wall to this jack, according to one of	Antenna
the diagrams shown to the right.
Remove the back of the optional remote
and put in two AA batteries.
	Flat wire	ANTENNA
	(300 ohm)	CABLE	TV SPEAKER
		M.P.I.	VIDEO IN SPEAKER OUT
			PILLOW SPEAKER
Back of
Remote			AUDIO IN
	300/75 ohm	TV Back Panel
	Adapter	(Expanded View)

4

5

Plug in the TV. The HealthView TV is designed to operate on standard current, 120-volt 60 Hertz AC. Do not attempt to operate it on DC Power.

Go to page 11 to Auto Program the TV.

Antenna

TV Back

ANTENNA

CABLE

TV SPEAKER

If you have a 75 ohm RF cable, then you don’t need any adapters.

RF Coaxial Wire (75ohm)

A 300 to 75 ohm adapter is not included with the Zenith HealthView TV.

M.P.I.	VIDEO IN SPEAKER OUT
	PILLOW SPEAKER
	AUDIO IN

TV Back Panel

(Expanded View)

Mini Glossary

75 OHM RF CABLE

300 TO 75 OHM ADAPTER

The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV.

A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end.

Page 6