Zenith XBS344 warranty Connections Basic TV Connections, Optional TV Connections

Connections (Continued)

Basic TV Connections

Make one of the following connections, depending on the capabilities of your TV.

RF coaxial connection

Connect the RF.OUT jack on the DVD/VCR Receiver to the antenna in jack on the TV using the 75-ohm Coaxial Cable supplied (R).

ote

If you use this connection, tune the TV to the DVD/VCR Receiver’s RF output channel (CH 3 or 4).

How to set the DVD/VCR Receiver’s RF output chan- nel

While the DVD/VCR Receiver is turned off, press and hold CH/PRESET (v/V) on the front panel for about five seconds to change the RF output channel (CH 03 or CH 04). “RF 03” or “RF 04” appears in the display win- dow.

Audio/Video connection

1	Connect the DVD/VCR VIDEO OUT jack on the
	DVD/VCR Receiver to the video in jack on the TV

using the supplied video cable (V).

2 Connect the Left and Right DVD/VCR AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

ote

If you use this connection, set the TV’s source selector to VIDEO.

Typical TV Connections Panel

ANTENNA	AUDIO INPUT		VIDEO	COMPONENT/PROGRESSIVE			S-VIDEO
INPUT			INPUT		SCAN VIDEO INPUT		INPUT
	L	R	L	Pr	Pb	Y

R A V C S

DVD+VCR Connections Panel

Optional TV Connections

ote

The S-VIDEO OUT and COMPONENT/PROGRESSIVE SCAN VIDEO OUT connection options below only work with DVD playback. The tuner and VCR will still output through the RF.OUT (R) or DVD/VCR OUT (A, V) jack. (See left)

S-Video Connection

1	Connect the S-VIDEO OUT jack on the DVD/VCR
	Receiver to the S-Video in jack on the TV using the

supplied S-Video cable (S).

2 Connect the Left and Right AUDIO OUT jacks on the DVD/VCR Receiver to the audio left/right in jacks on the TV using the supplied audio cables

(A).

Component Video (Color Stream®) connection

1 Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using user-sup- plied Y Pb Pr cables (C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

Progressive Scan (ColorStream® pro) connection

If your television is a high-definition or “digital ready” television, you may take advantage of the DVD/VCR Receiver’s progressive scan output for the highest video resolution possible.

If your TV does not accept the Progressive Scan for- mat, the picture will appear scrambled if you try Progressive Scan on the DVD/VCR Receiver.

1 Connect the COMPONENT/PROGRESSIVE SCAN VIDEO OUT jacks on the DVD/VCR Receiver to the corresponding in jacks on the TV using an optional Y Pb Pr cable (C).

2 Connect the Left and Right AUDIO OUT jacks of the DVD/VCR Receiver to the audio left/right in jacks on the TV (A) using the supplied audio cables.

otes

–Set Progressive Scan to “On” on the DVD setup menu for progressive signal, see page 21.

–Progressive scan does not work with the analog video connections (yellow VIDEO OUT jack).

12