26
8. Operation
English
It is very dangerous to run a chainsaw that mounts
broken parts or lacks any parts.
Before starting engine, make sure that all the parts
including bar and chain are installed properly.
■STARTING ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely. (F8-1)
2. Put the switch to "I" position. (F8-2)
3. While holding the throttle lever together with the
throttle interlock, push in the side latch and release
the throttle lever to hold it at the starting position.
(F8-3)
(1) Chain oil (2) Fuel
(3) Switch (4) Latch
(5) Throttle lever (6) Throttle interlock
(7) Choke knob
4. Pull out the choke knob to the closed position. (F8-
4)
When restarting immediately after stopping the engine,
Ieave the choke knob at the open position.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously. (F8-5)
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch your
body. It's very dangerous.
6. When engine has ignited first, push in the choke
knob and pull the starter again to start the engine.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
Keep clear of the saw chain as it will start rotatIng
upon starting of engine.
WARNING
WARNING
NOTE
WARNING
F8-1
F8-2
F8-3
F8-4
F8-5