Zhone Technologies 08-01002-01 manual Installing the Wall Mount Filter, Task, Stop

Action

Installing the Elite Modem 1-9

Task:

Installing the Wall Mount Filter

It is important that the telephone filters be installed correctly. Follow these instructions precisely. If the telephone filter is installed incorrectly (reversed), the filter will not allow voice signals to pass. (See Figure 1-2, Wall Mount Filter Installation.)

Step

1Check for a dial tone.

6Remove the telephone from its wall mount by pushing it upward and pulling it away from the mounting pins. The telephone may have a short “pig tail” line cord connecting it to the jack. If the phone has a “pig tail” line cord, disconnect it from the wall jack.

7Plug the filter’s short “pig tail” line cord into the wall jack.

8Install the wall mount filter by placing it over the wall jack and sliding it downward until it is seated on the mounting pins.

9Plug the telephone “pig tail” line cord into the jack located on the front of the filter.

10Install the telephone on wall mount filter.

11Verify dial tone. If a dial tone is not present, check all connections.

Figure 1-2. Wall Mount Filter Installation

STOP

You have completed this task.

Revision 2.01 Elite Modem Installation Guide 08-01002-01