Hardware Installation and PC Setup
4.Connect the AC power adapter to the POWER connector on the back of the device and plug the adapter into a wall outlet or power strip.
|
| RESET |
LINE PHONE | USB | LAN DEFAULT POWER |
1 |
| 4 |
2 |
| |
| 3 |
OR
Figure 3: Hardware Installation
5.Turn on and boot up your PC and any LAN devices, such as hub or switches, and any computers connected to them.
6.Verify that the router's LEDs are illuminated as shown in Table 3.
Table 3: LED Indicators (Sheet 1 of 2)
This LED . . . | Should be: |
|
|
POWER | Solid green to indicate that the device is turned on. If this |
| light is not on, check if the power adapter is attached to the |
| router and plugged into an AC power source. |
|
|
STATUS | Solid green to indicate that the router can communicate |
| with your ISP via ADSL, or flashing when the router is |
| trying to connect to your ISP. |
|
|
ACTIVITY | Flashing when the device is sending or receiving data over |
| the ADSL connection. |
|
|
18
